![]() ![]() Until quite recently, gas detection was widely considered to be ‘just another aspect of personal protection equipment (PPE)’, with gas detectors being fairly basic pieces of kit that detected gas hazards and nothing more. To note, although it is normal for a whole system to be allocated a level of protection, it is also possible for different parts of the system to have different levels of protection. This level is given for ‘normal operation’ with a unity factor of safety is generally acceptable in infrequently hazardous areas (Zone 2). This level is considered adequately safe with one fault is considered safe for use in less frequently hazardous areas (Zone 1). Offers the highest level of protection and any equipment that is given this level is generally considered adequately safe for use in the most hazardous locations (Zone 0) with two faults. Intrinsic safety relates to three levels of protection, ‘ia’, ‘ib’ and ‘ic’ that aim to balance the probability of an explosive atmosphere, assessing the probability of whether that is an ignition capable situation that may occur. Additionally, the maintenance and diagnostic work can be performed without shutting down production and ventilating the work area. It prevents the cost and bulk of explosion proof enclosures, with additional cost savings as a result of the ability to use standard instrumentation cables. The main advantage is that it provides a solution to all problems that occur in a hazardous area regarding equipment. Crowcon detection instruments ltd a halma company code#Equipment or devices that may be made intrinsically safe must first be approved for use in an intrinsically safe system through a competent authority, such as the National Fire Protection Agency (NFPA), the Canadian Standards Association (CSA), Underwriters Laboratories (UL), Factory Mutual (FM), National Electric Code (NEC), and the Instrument Society of Measurement and Control (ISA). Intrinsic safety is achieved with the use of a Zener Diodes which limits voltage, resistors that limit the current and a fuse to cut off electricity. Hazardous spaces may belong, but are not limited to, to the following: petrochemical refineries, mines, agriculture grain storage, wastewater, distilling, pharmaceutical, brewing, and utilities. ![]() Intrinsic safety prevents sparks and heat from being generated from any electrical equipment, devices or instruments that otherwise ay have initiated an explosion in a hazardous area. Areas subject to flammable gas hazards are classified as either Zone 0, Zone 1 or Zone 2. Hazardous places are classified in terms of zones on the basis of the frequency and duration of the occurrence of an explosive atmosphere. Food processing factories, grain handling facilities, recycling operations, and even flour mills generate combustible dust, which is why these are classed as too hazardous locations. ![]() This is because when they are mix with oxygen within the air, they can establish an explosion-prone environment. The main safety issue in these industrial scenarios is that of flammable vapours and gases. Hazardous industrial areas include oil refineries, mining, distilleries and chemical plants. What is a hazardous area?Ī hazardous or explosion-prone relates to an environment that has vast amounts of flammable substances such as combustible particles, gases, vapor. This technique uses a low-energy signalling technique that reduces the energy within the equipment to below that required to initiate an explosion, whilst maintaining an energy level this is an be used for its operation. Intrinsic safety is an explosion prevention technique used to ensure safe operation of electrical equipment in a hazardous area. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |